I have to change a rear break light on my 95 Corolla and am having dificulty getting the rear tail light assembly off to get at the bulb. I have taken off the 2 screws from the outside, and the one nut on the bolt from the inside of the trunk, but there are 2 clips on the side portion protruding into the trunk which I can't figure out how to remove. Any ideas?
Rear break/signal light bulb on 95 Corolla?
you should not need to remove the assembly. open the trunk and pull the cover away from the lamp assembly area. You will see the bulb housings. Twist and pull the housing for the failed bulb and replace the bulb. reverse the procedure and your done
Rear break/signal light bulb on 95 Corolla?
Doesn't the bulb holder just unscrew a little and pull out of the housing from inside the trunk?
you should be able to slide the tail light out sideways away from the middle of the car. make sure the lens moves a little first some cars the tail lights are glude in with a rubber compond to seal them.
My Idea..........Look in the manual - it'll tell you in there how to do it.
Subscribe to:
Post Comments
(Atom)
No comments:
Post a Comment